OUTPUT PORT ATT (Output port
attenuation) screen
In this screen you can specify the amount of attenuation
for each output channel and for each output channel of an
I/O card.
OUTPUT PORT ATT
1
A DISPLAY MODE
Select the channels that will appear in the display, from
the following choices.
• OUTPUT
The screen will show the amount of attenuation for
output channels (MIX channels 1–24, MATRIX chan-
nels 1–8, STEREO A L/R channels, STEREO B L/R
channels), CUE L/R channels, MONITOR L/R/C chan-
nels, and 2TR OUT DIGITAL 1–3 L/R channels.
• SLOT 1-4
The screen will show the amount of attenuation for
each output channel of the I/O cards installed in slots
1–4.
B ø (phase)
If this button is on, the phase of the output port will be
reversed.
C ATT (Attenuation)
Adjusts the amount of attenuation for each channel.
Move the cursor to the box, and turn the [DATA]
encoder to adjust the value in a range of –9 to 0 dB.
DITHER screen
In this screen you can turn dithering on/off and specify the
bit depth for dithering. These settings are made individu-
ally for each digital output jack and each output channel of
the digital I/O cards.
A Digital output jack dither
2 3
settings
Specify the number of bits (16,
20, 24 bits) used when dither-
ing the output signals from 2TR
DIGITAL OUT jacks 1–3. If you
select OFF, dithering will not be
performed.
B Slots 1–4
This area shows the type of digital I/O card installed in
each slot.
C Digital I/O card dither settings
For each output channel of the digital I/O cards
installed in the slots, specify the number of bits used
when dithering.
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
DITHER
1
2
3
Reference section
229