Lcr Screen - Yamaha DSP5D Owner's Manual

LCR screen

Here you can make settings for LCR mode, which allows
three-channel playback by adding a CENTER channel to
the L/R channels of the STEREO bus. This function can be
used only with MIX channels.
LCR
1
2
3
4
A Response graph
These graphs indicate the approximate LCR response
for each MIX channel. The graph will change as the
2 ) is edited.
CSR knob (
B CSR (Center Side Ratio)
This knob adjusts the proportional level of the CEN-
TER channel relative to the L/R channels. The range is
0–100%.
If the CSR knob is set to 0%, turning the PAN knob in
the MIX TO STEREO area of the MATRIX/ST ROUT-
ING screen (or the [PAN] encoder in the SELECTED
CHANNEL section) will change the signal levels of the
L/R channels as shown below.
L C
[PAN] encoder
In this case, MIX TO STEREO PAN will operate as a
conventional PAN control, and no signal will be sent to
the CENTER channel.
Signal sent to the
L channel
Signal sent to the
R channel
R
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
If CSR is set to 100%, turning the PAN knob ([PAN]
encoder) will change the signal levels of the L/R chan-
nels as shown below.
L C
[PAN] encoder
When the PAN knob ([PAN] encoder) is in the center
position, the signal level of the CENTER channel will
be at maximum, and no signal will be sent to the L/R
channels.
C LCR (LCR mode on/off)
For each MIX channel, this turns LCR mode on/off.
For channels where LCR mode is turned on, the PAN
knob in the MIX TO STEREO area of the MATRIX/ST
ROUTING screen can be used to simultaneously con-
trol the levels of the L/R channels and the CENTER
channel.
If you have selected a MIX channel for which LCR is
on, you can also use the [PAN] encoder in the
SELECTED CHANNEL section of the top panel. In
this case, the peripheral LEDs will change as follows
when you operate the [PAN] encoder.
• When LCR = off
L R L
• When LCR = on
L R L
Note
In order to use the LCR function, the USE AS CENTER BUS
button must be turned On in the MIXER SETUP screen (SYS/
W.CLOCK function) ( ➥ p.222). Be aware that when this but-
ton is on, the CENTER channel signal is not sent to the
STEREO B bus, and will not play back appropriately. (In this
case, the STEREO B bus is sent the same signal as the STE-
REO A bus.)
Reference section
Signal sent to the
C channel
Signal sent to the
L channel
Signal sent to the
R channel
R
R L R
R L R
267