Midi Remote Function; Midi Setup Screen - Yamaha DSP5D Owner's Manual

MIDI REMOTE function

3
C DESTINATION SCENE (Paste-destination
scene)
This list lets you select the scenes to which the data will
be pasted. If you want to select multiple consecutive
scenes as the paste-destination, select the starting num-
ber in the upper list and the ending number in the
lower list. (If you're pasting to only one scene, select
the same scene in the upper and lower lists.)
You can change the order in which the list is sorted by
clicking the buttons shown at the top of the scene
number, SCENE TITLE, TIME STAMP, or COM-
MENT columns.
D PASTE
This button executes the Global Paste operation. When
you click this button, a confirmation message will
appear.
In the case of parameters such as those listed below, of
which only one exists for each two adjacent odd-num-
bered/even-numbered channels or modules, the
parameter will be pasted only if both channels/mod-
ules are specified for pasting.
• GATE STEREO LINK
• COMP STEREO LINK
• DELAY GANG
• PAN MODE
• GEQ LINK
• ATT GANG
• MS DECODE
• FIXED/VARI
Note
• Paste is valid even in PREVIEW mode.
• When you paste to a scene, there may be cases in which a
conflict in pairing settings causes the settings of a parame-
ter to differ between L and R channels. In such cases, the
parameter will be recalled with those settings, and will be
linked when it is next operated.
188
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
4
Reference section
MIDI REMOTE function
Note
The various MIDI REMOTE function screens other than the
DME CONTROL screen are invalid if the DSP5D is selected.

MIDI SETUP screen

Here you can select the types of MIDI message transmitted
and received by the PM5D, and select the MIDI port that
will be used.
MIDI SETUP
1 2
A MODE
Here you can select the way in which program changes
and control changes will be transmitted/received.
• PROGRAM CHANGE MODE
In this area you can select the program change trans-
mission/reception method.
SINGLE
If this button is on, program changes will be trans-
mitted/received on a single MIDI channel (Single
mode).
OMNI ON/OFF
If this button is on, program changes of all MIDI
channels will be received in Single mode (this is
unavailable in Multi mode).
3 4