Head Light Switch; Hazard Light Switch; Turn Signal Light Switch - Kubota RTV-X900 Operator's Manual

18 OPERATING THE VEHICLE
5. Selecting light switch position.
BHead Light Switch
The head light switch is operative when the key switch is
in the "ON" position.
Turn on the key switch and turn the head light switch
clockwise to the "ON" position, the head lights light up.
Turn the head light switch counterclockwise to the "OFF"
position to turn off the head light.

(1) Head light switch

A Turning the head light switch to the "ON" position
causes the following lamps to light simultaneously.
(1) Tail lights (lamps at the rear portions of the
vehicle)
(A) Head lights "OFF"
(B) Head lights "ON"
BHazard Light Switch
[if equipped]
Press the hazard light switch, the hazard light flash along
with the indicator on the instrument panel.
Press the hazard light switch again to turn off the hazard
light.
A The hazard light switch is operative when the key
switch is in either the "ON" or "OFF" position.
Be careful that leaving the switch "ON" causes the
battery to run out.
BTurn Signal Light Switch
[if equipped]
To indicate a right turn, turn the turn signal light switch
clockwise.
To indicate a left turn, turn the turn signal light switch
counter-clockwise.
When the left or right signal is activated, the indicated
turning light will flash and the other will stay on.
The indicator lamp at the instrument panel also flashes
like the above.
A The turn signal light switch is only operative when the
key switch is in the "ON" position.
A If the hazard light switch is pressed to the "ON"
position while the turn signal is activated, the indicated
turning light will flash and the other will stay on.
A Be sure to return switch to center position after turning.

(1) Turn signal light switch

(A) "RIGHT TURN"
(B) "LEFT TURN"