Xerox PHASER 8500 Service Manual page 126

Error Messages and Codes
3-58
Jam Code Troubleshooting Procedures (Continued)
T2M The Exit Cover open flag unexpectedly tripped when the printer picked from
Tray 2.
T2N The Exit Cover open flag unexpectedly tripped when the printer picked from
Tray 3.
T2P The Exit Cover open flag unexpectedly tripped when the printer picked from
Tray 4.
T2Q The Exit Cover open flag unexpectedly tripped when the printer picked from
Tray 1.
T2R The Exit Cover open flag unexpectedly tripped while the printer was duplexing.
T2S The Exit Cover open flag unexpectedly tripped while the paper was staging for
the transfix cycle.
T2T The Exit Cover open flag unexpectedly tripped while the print was being
transfixed.
T2X The Exit Cover open flag unexpectedly tripped while the printer was ejecting
the print.
T2Z The Exit Cover open flag unexpectedly tripped while the printer was shutting
down.
1. Ensure the media is supported.
2. Ensure ground integrity of the printer, see page 4-65.
3. Run the Monitor Sensors test.
4. Inspect the door switch for damage and proper operation.
5. Check the Drum maintenance unit to ensure it is functioning properly and
the blade is not covered with ink debris.
6. Replace the Drum maintenance unit.
7. Replace the transfix roller.
V2D Tray 2 media size sensor unexpectedly activated during warm-up.
V2E Tray 2 media size sensor unexpectedly activated during printer ready.
V2F Tray 2 media size sensor unexpectedly activated while printer was in a fault
state.
V2K Tray 2 media size sensor unexpected event during oil transfix.
V2L Tray 2 media size sensor unexpectedly activated while the printer was in
standby.
V2M Tray 2 media size sensor unexpectedly activated while picking from Tray 2.
V2N Tray 2 media size sensor unexpectedly activated while picking from Tray 3.
V2P Tray 2 media size sensor unexpectedly activated while picking from Tray 4.
V2Q Tray 2 media size sensor unexpectedly activated while picking from Tray 1.
V2R Tray 2 media size sensor unexpectedly activated while duplexing.
V2S Tray 2 media size sensor unexpectedly activated while paper staged for print.
V2T Tray 2 media size sensor unexpectedly activated while transfixing the print.
V2V Tray 2 media size sensor unexpectedly activated while print Drum
maintenance cycle was being performed.
V2W Tray 2 media size sensor unexpectedly activated during printer imaging.
Phaser 8400/8500/8550/8560 Color Printer Service Manual