9,0Xx.xx Errors - Ink Loader Faults - Xerox PHASER 8500 Service Manual

9,0XX.xx Errors - Ink Loader Faults

Phaser 8400/8500/8550/8560 Color Printer Service Manual
9,000.44: Ink Loader device fault
9,005.49:The cyan ink melt heater is On, but ink is not dripping.
9,006.41: The magenta ink melt heater is On, but ink is not dripping.
9,007.42:The yellow ink melt heater is On, but ink is not dripping.
9,008.43: The black ink melt heater is On, but ink is not dripping.
9,015.4x through 9,018 (8500/8550/8560 only):
opened to clear an ink jam, the following codes are recorded: 9,01x.41, where
x= 5 for cyan, 6 for magenta, 7 for yellow, and 8 for black.
9,025.4x through 9, 028 (8500/8550/8560 only):
opened for a second time, the following codes are recorded: 9,02x.41, where
x= 5 for cyan, 6 for magenta, 7 for yellow, and 8 for black.
9,035.43 through 9,038 (8500/8550/8560 only):
stuck after melting 2.5 ink sticks. The following codes are recorded: 9,03x.41,
where x= 5 for cyan, 6 for magenta, 7 for yellow, and 8 for black.
Features on the bottom of genuine Xerox ink sticks actuate the Ink Out
Sensor located at the forward end of each ink channel of the Ink Loader. The
sensor indicates the passage of ink to provide a count of ink consumption.
Damaged or non-genuine ink sticks may not reliably actuate the sensors. This
can lead to false Ink Out messages as well as Ink Stick count faults. Using
8400 model ink in a 8500/8550/8560 models will also cause 9,03x.4x ink stick
count faults.
Troubleshooting Procedure for Ink Loader
Step Questions and Actions
Is the ink Genuine Xerox? Are they the
1
correct sticks for the model?
Manually verify that the ink stick is able
2
to advance in the ink loader chute.
Check for broken or wrong type ink
sticks.
Error Messages and Codes
When the Ink Loader door is
When the inkloader door is
Ink count sensor flags are
Yes No
Go to Step 2. 1. Advise customer.
2. Replace the Ink
with Xerox Ink.
3. Run Clear ISC
Fault test to clear
the error. The
Clear ISC Fault is
located in the
Internal
Diagnostics
Function menu.
Go to Step 3. 1. Remove any
blockage and/or
replace the ink
stick.
2. Replace the Ink
Loader.
3. Run Clear ISC
Fault test to clear
the error.
3-23