7,0Xx.4X Errors- Printhead Tilt Faults - Xerox PHASER 8500 Service Manual

Error Messages and Codes

7,0XX.4x Errors- Printhead Tilt Faults

3-16
Troubleshooting Procedure for 7,006 Error Code (Continued)
Step Questions and Actions
Review instructions for 7,008.xx and
4
7,010.xx fault codes.
The 7,007.49, 7,008.41, 7009.42, and 7,010.43 errors indicate that the
Printhead was unable to tilt normally on its axis. Possible causes include:
■
The printer was powered off in the middle of a cleaning cycle and the
Wiper Blade has frozen to the Printhead.
■
A Drum Maintenance Camshaft lobe is broken and holding the Drum
Maintenance Kit's oil roller against the Drum when it should be retracted
to its home position.
■
Process Drive not being aligned correctly.
■
A damaged Printhead Restraint.
■ Ink spilled in the Roll Block preventing proper Printhead motion.
■
Ink or other debris under the Printhead preventing proper motion.
■
The Wiper Assembly not being aligned correctly or ink spilled in the wiper
tracks.
■
The Head Tilt Gear not being homed correctly.
■ The X-Axis Motor nose cone not being installed correctly.
■
The ferrite torrid on the Printhead interface cable has slipped behind the
Printhead causing the Printhead to bind when it tilts backwards.
■
The black plastic shroud on the back of the Printhead is snapped off and
binding the Printhead when it tilts back.
Caution
After servicing the printer, manually set the following assemblies to their
home position before powering on the printer. See Section 6 for
instructions on setting these components to their home positions.
■
Printhead (tilted forward and disengaged from Printhead tilt gear)
■
Head Tilt Gear (disengaged from Process Drive train; arrows on left
frame point to each other)
■
Wiper Assembly (bottom of travel)
■ Process Drive (holes on Transfix Camshaft and Drum Maintenance
Camshaft line up with marks on frame, large gears within assembly
line up with holes in Process Drive housing)
Phaser 8400/8500/8550/8560 Color Printer Service Manual
Yes No
Follow recommended actions
for error codes and reboot the
printer.