Inserting And Removing Devices; Inserting The I/O Module; Figure 8: Insert I/O Module (Example); Figure 9: Snap The I/O Module Into Place (Example) - WAGO 753-1630 Manual

753-1630 SMI Master Module 230 V AC
Pos: 90.6 /Alle Serien (Allgemeine Module)/Überschriften/Ebene 2/Geräte einfügen und entfernen - Überschrift 2 @ 3\mod_1231768483250_21.docx @ 25950 @ 2 @ 1
6.2

Inserting and Removing Devices

Pos: 90.7 /Alle Serien (Allgemeine Module)/Sicherheits- und sonstige Hinweise/Achtung/Achtung: Arbeiten an Geräten nur spannungsfrei durchführen! @ 6\mod_1256193963573_21.docx @ 43426 @ @ 1
Perform work on devices only if they are de-energized!
Working on energized devices can damage them. Therefore, turn off the power
supply before working on the devices.
Pos: 90.8 /Serie 750 (WAGO-I/O-SYSTEM)/Montieren/Demontieren/I/O-Modul einfügen @ 3\mod_1231769726703_21.docx @ 25989 @ 3 @ 1
6.2.1

Inserting the I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 8: Insert I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 9: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
Pos: 90.9 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
Version 1.2.0 FW/HW Version 02/01
Mounting 49
Manual