O 2 Sensor; Spirolog Infinity Id And Spirolife Flow Sensors; Sterilization; All Components With The Suitable Reprocessing Options Are Listed In The Care List For Fabius Plus Components Page 172. Follow The Hygiene Regulations Of The Hospital - Dräger Fabius plus Instructions For Use Manual

O sensor
2
CAUTION
Risk of equipment damage
The O sensor must not be sterilized or disin-
2
fected.

Spirolog Infinity ID and SpiroLife flow sensors

Reprocess the flow sensors in accordance with the
corresponding Instructions for Use.
CAUTION
The flow sensors must not be reprocessed in a
washer-disinfector. Do not clean with compressed
air, water jet, brush, etc. Otherwise, the thin wires
in the flow sensors may be destroyed. The
Spirolog and Infinity ID flow sensors must not be
sterilized in hot steam. The flow sensors are not
resistant to high temperatures and will be
destroyed.
CAUTION
Only use clean disinfectant solutions to disinfect
the flow sensors. Contaminants, e.g., lint, may
lead to the destruction of the flow sensors.
WARNING
Risk of fire hazard
Allow the flow sensors to dry in air for at least
30 minutes after the use of disinfectants con-
taining flammable substances. These sub-
stances give off vapors that could ignite
during calibration.
CAUTION
The flow sensors can only be reused as long as
automatic calibration is possible.
Instructions for Use Fabius plus SW 3.n

Sterilization

CAUTION
Risk of damage to the medical device
The Spirolog and Infinity ID flow sensors must not
be sterilized.
Strictly follow the correct Instructions for Use.
Steam sterilization at 273 °F (134 °C).
CAUTION
Risk of damage to the medical device
SpiroLife flow sensors are not suitable for plasma
or radiation sterilization.
Strictly follow the correct Instructions for Use.
All components with the suitable reprocessing
options are listed in the care list for Fabius plus
components page 172. Follow the hygiene regula-
tions of the hospital!
Cleaning
171