Power-Up Procedure/Checklist - Christie Roadie HD+35K Setup Manual

3.3

Power-up Procedure/Checklist

This is a typical manual power-up procedure. Some installations may include an automation system that
NOTE:
controls projector start-up and lamp ignition in conjunction with other variables such as lighting, audio
and other equipment.
The following steps provide a checklist of steps for the Power-up procedure:
1. Make sure that ballast is properly configured for the AC at your site, and that it is connected via 4 cables to
the projection head. See
At this point, the projection head is in "standby" mode only. The voltmeter displays the incoming voltage,
the adjacent main PROJ. STATUS light yellow, and the light engine compartment fans running. The rest of
the projection head should be OFF.
2. Connect the ballast's integral three-phase 30-amp line cord to your AC supply according to your site.
3. Confirm the ballast's three-phase status lights are ON and the adjacent voltmeter displays an acceptable
AC level for your ballast, and region. See
4. Set the breaker/power switch to ON. Listen for the internal cooling fan to start-up.
There is no other indication of whether the ballast is ON or not.
NOTE:
5. Press M
ENU
6000 watts, depending on its last setting (factory default=6000). Enter the Lamp password.
The password is required unless the
NOTE:
6. Press P
OWER
When the Status Display shows the correct lamp type, the projector, and lamp can be switched ON.
7. Press and hold the P
STATUS light at the rear of the projector should be green when the projector is up-and-running. For best
results, let the projector warm up for about 5 minutes.
If the Lamp Does Not Ignite, check:
• If a safety interlock switch is open (such as when the lamp door is ajar), the lamp cannot be struck. The
PROJ. STATUS light on the rear of the projector glows red, and an error appears on the status display,
and LCD window.
• If the lamp fails to ignite even though the interlock system is OK, the projector automatically tries to re-
ignite using 100% of the maximum power acceptable for the installed lamp. If this re-try fails, the lamp
likely needs replacement.
For complete power-up troubleshooting, Refer to
NOTE:
8. In the Lamp menu, set the "Cable Length (m)" to match the length of the DC cables currently connected
between your ballast and projection head.
For more information, see
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)
Do not attempt operation if the AC supply is not within the specified voltage range.
Section 2.5 Connecting the
. The Status Display at the rear of the projector displays a "Lamp Size" of 2000, 3000, 4500 or
and use the U
A
P RROW
button to turn the projection head ON and ignite the lamp. The main PROJ.
OWER
Section 2.1.1 Quick
Ballast.
Section 5 Specifications
Enable Password service option has been turned OFF.
" "
to locate, and select which lamp is currently installed.
5 Specifications
Setup.
Section 3: Operation
for details.
.
3-5