Programming an Extension
Step by Step
0 1
58
Enter the code for programming.
3 0
...
Enter the length of time (01 to 99 in 5-second incre-
9 9
ments) where 01 = 5 seconds... 06 = 30 seconds
(default).
Initial state for Programming Mode.
Dialing Mode
The Dialing Mode designates the dialing method as
pulse (DP), tone (DTMF) or automatic detection.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
6 8
Enter the extension number (e.g., 12/102).
...
Enter the code for the dialing mode:
0
2
= Automatic detection of Dialing Mode (default)
0
= Pulse
1
= Tone
2
Enter the next extension number
or
Press this key.
#
Initial state for Programming Mode.
Flash Detection Time
The Flash Detection Time is the maximum period of
time required by a PABX to detect a flash signal gener-
ated by an internal telephone. If older MF dialing
telephones are connected to the system, it may be
necessary to adjust the Flash Detection Time to their
response times (see manufacturer's instructions). The
specified Flash Detection Time may vary for different
countries.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
3 1