Setting The Time For An External Room Monitor; Types Of Caller Lists - Siemens HiPath 1100 Series Programming Manual

General Programming
Step by Step
0 1
1
80
or
* Deletes the music source extension.
Initial state for Programming Mode.
Setting the Time for an external Room
Monitor
If the Fax/DID module is installed in the system you can
run the Room Monitor feature (Babyphone) from an
external telephone. Set the time for an automatic call
disconnect.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
6 9
... Enter the length of time (01 to 99 seconds) for external
9 9
monitoring. The default setting is 10 seconds.
Initial state for Programming Mode.

Types of Caller Lists

This setting specifies if only external calls or all internal
and external calls should be displayed in the Caller Lists.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 4 9
or
Select the type of Caller List:
2
= External
1
= Internal and external (default)
2
Initial state for Programming Mode.