Cos Changeover; Required: Programming Mode Must Be Active - Siemens HiPath 1100 Series Programming Manual

Main Configurations
Step by Step
*
26
:
D
:
N
Instead of entering
= No Trunk Access (No Permission)
0
= Outward-Restricted Trunk Access with Denied
1
List 1 (4 entries)
= Outward-Restricted Trunk Access with Denied
2
List 2 (10 entries)
= Outward-Restricted Trunk Access with Denied
3
List 3 (35 entries)
= Outward-Restricted Trunk Access with Permis-
4
sion List 1 (4 entries)
5 = Outward-Restricted Trunk Access with Permis-
sion List 2 (10 entries)
= Outward-Restricted Trunk Access with Permis-
6
sion List 3 (25 entries)
= Unrestricted Trunk Access (default for all lines)
7
... Enter the extensions (e.g., 11/101) to which the COS
selected will be assigned.
Press this key.
#
Initial state for Programming Mode.
To assign a COS to additional lines, repeat the program-
ming steps described above.

COS Changeover

You can allow or deny a temporary COS Changeover
from an extension to a different extension.

Required: Programming Mode must be active (*95

31994).
Enter the code for programming.
7 8
Enter the extension number (e.g., 11/101).
or To allow/deny COS Changeover:
#
* = To allow
= To deny (default)
#
Enter COS for Day Service
Enter COS for Night Service
or
D
enter the following COS:
N