Timer For Deactivating The Relay; External Ring For Activating The Relay - Siemens HiPath 1100 Series Programming Manual

Step by Step
...
0 0 0

Timer for Deactivating the Relay

Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
7 3
Enter the length of time (000 to 255) that the relay must
2 5 5
remain closed. One unit equals 0.5 seconds.
The default is "002" = 1 second.
Press this key.
#
Initial state for Programming Mode.

External Ring for Activating the Relay

This setting lets you use the relay to control a second
ring signal for an analog extension.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 7 1
Enter the extension number (e.g., 12/102).
Initial state for Programming Mode.
Relay and Sensor on the HiPath 1120
If the closing time is set to "000," the relay will
remain active until it is manually deactivated.
133