Attendant Console (Ac) - Siemens HiPath 1100 Series Programming Manual

Main Configurations
Step by Step
30

Attendant Console (AC)

The Attendant Console centralizes the flow of calls at
up to two answering stations equipped with system
telephones with a display. In the default configuration
no Attendant Console is configured.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
5 0
Enter an extension number for the Attendant Console
(e.g., 12/102).
Enter the next extension number, if you like.
or
Press this key.
#
Initial state for Programming Mode.
Deleting an Attendant Console
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
5 0
*
Delete all Attendant Consoles.
Press this key.
#
Initial state for Programming Mode.
The Attendant Console does not receive "Direct
message to speakerphone" and it must not
belong to any Associated Group.
Only the first Attendant Console can called by
entering 9. For the second terminal you must
enter the extension number.