External Line Call Direction; Flash Duration - Siemens HiPath 1100 Series Programming Manual

Step by Step
1

External Line Call Direction

When a user tries to access a line, lines that have been
previously programmed as outgoing are given priority. If
an incoming call is received over that line, however, it
will come through as usual.
To avoid this situation the method for accessing external
lines can be defined at the time of making or receiving
a call. This facility is usually contracted with the local
carrier to ensure optimal usage of all lines available.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
5 5
Enter a number for an external line (e.g., 801).
... Enter the number for the type of access to an external
3
line:
= Bidirectional (default)
1
= Unidirectional incoming
2
= Unidirectional outgoing
3
Enter the next external line number.
or
Press this key.
#
Initial state for Programming Mode.

Flash Duration

The duration of the Flash signal that is sent by the
system to each external analog line can be configured
individually. Flash signal duration depends on the
specific setting for each country.
If the country configuration(
external analog line (
Duration will automatically reset to the default value.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 8
Enter a number for an external analog line (e.g., 801).
Programming an External Line
page 27) or the type of
page 17) is changed, the Flash
35