Call Groups (Cg) - Siemens HiPath 1100 Series Programming Manual

Programming an Extension
Step by Step
0 0
44
...
5 9 Enter the length of time for the Alert Ring Signal (00 to
59 seconds).
or
* Disable the Alert Ring Signal (default).
Initial state for Programming Mode.

Call Groups (CG)

Extensions can be grouped in Call Groups (CG) that can
then be accessed through numbers 770 to 779.
Whenever this number is dialed, every telephone in the
group rings until one of them answers.
In the default configuration the first 10 extensions in
HiPath 1100 systems belong to Call Group 770.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 3
Enter the Call Group number (770 to 779).
...
Enter the extension numbers (up to 10 extensions -
e.g., 11/101) to be included in the Subscriber Group.
Press this key.
#
Initial state for Programming Mode.
Deleting Extensions from a Call Group (CG)
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 3
Enter the Call Group number (770 to 779).
*
All extensions belonging to the Call Group selected are
deleted.
Press this key.
#
Initial state for Programming Mode.