Call Charge Alert For Analog Extensions; Timer For Outgoing External Calls - Siemens HiPath 1100 Series Programming Manual

Programming an Extension
Step by Step
*
70
Press this key.
#
Initial state for Programming Mode.
Call Charge Alert for Analog Exten-
sions
This setting allows you to transmit billing pulses to an
analog extension.
Required: Telephone with a display and Programming
Mode activated (*95 31994).
Enter the code for programming.
0 4 1
Enter the analog extension number (e.g., 11/101).
or Activate/Deactivate transmission of billing pulses:
#
* = To activate
= To deactivate (default)
#
Enter the next analog extension number
or
Press this key.
#
Initial state for Programming Mode.

Timer for Outgoing External Calls

This setting specifies a maximum time for the duration
of an outgoing external call for each extension.
The time count starts upon connection of a call and it
never restarts while the call is in progress (e.g., when
there is a transfer). Once the time expires, the call is
terminated.
In the default configuration the maximum time for the
duration of outgoing external calls is 180 seconds for all
extensions.
Required: Programming Mode must be active (*95
31994).
Please refer to the documentation provided with
the telephone set connected to the extension to
find out if billing indication is supported and
which transmission mode is used.