External Number For Updating The Software; Frequency For Sw Update - Siemens HiPath 1100 Series Programming Manual

Step by Step
h h
0 1
The default setting specifies the time for the update
process at 00:00 hours.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 8
: Enter the hour (00 to 23) and the minutes (00 to 59) for
m m
starting the update.
Initial state for Programming Mode.

External Number for Updating the Software

This setting specifies a number to be used by the
system to update the software.
The default configuration does not specify any number.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 6
Enter the external numbers (up to 20 digits).
Press this key to finalize the entry.
#
Initial state for Programming Mode.

Frequency for SW Update

This setting specifies regular intervals for transferring
data, in months. During a transfer the telephone
operates as usual.
The default setting specifies updates to be done in a
monthly basis.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 7
... Enter a timeout for the update (01 to 12) where 01 =
1 2
update every month (default) 12 = update every 12
months at a specified date.
Initial state for Programming Mode.
General Programming
87