Otto Bock 4R103 Instructions For Use Manual page 9

5.1 Mounting the adapter
> Required materials: 710D4 torque wrench, degreasing cleaner
(such as 634A58 isopropyl alcohol)
1) Loosen the tube clamp cap screw by 2 turns.
2) For final assembly: Degrease the insertion range of the tube
clamp adapter and tube adapter.
3) Fully insert the tube adapter into the tube clamp adapter up to the
stop. Align the clamping slot:
Tube clamp adapter: anterior
Tube clamp adapter, sliding: anterior or medial
4) Tighten the cap screw on the tube clamp, choosing the torque
according to the thread diameter (M4: 5 Nm, M5: 10 Nm,
M6: 13 Nm).
5.2 Installation in the modular prosthesis
Required tools and materials:
>
710D4 torque wrench, 636K13 Loctite®
► Install the other prosthetic components as described in the
respective instructions for use.
5.3 Adjusting the adapter
The proximal section of the tube clamp adapter is movable in a dove­
tail guide. A set screw acts as a stop. It is fastened in the desired pos­
ition.
Adjusting the stop
> Tools required:
710D4 torque wrench
► CAUTION! Only use the adapter with the set screw screwed
in!
Screw in the set screw at the desired position (installation torque:
5 Nm).
Moving the adapter
Tools required:
>
710D4 torque wrench
> No load on the prosthesis, or the prosthesis is not being worn.
1) Loosen the two cap screws of the dovetail guide (see fig. 1).
2) Move the proximal section of the tube clamp adapter in the dove­
tail guide. Note the maximum displacement (see fig. 2).
3) Tighten the two cap screws (installation torque: 15 Nm).
6 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
► The prosthetic components should be inspected after the first 30
days of use.
► Inspect the entire prosthesis for wear during normal consulta­
tions.
► Conduct annual safety inspections.
8 Disposal
This product may not be disposed of with regular domestic waste in
all jurisdictions. Disposal that is not in accordance with the regula­
tions of the country where the product is used may have a detrimental
impact on health and the environment. Please observe the information
provided by the responsible authorities in the country of use regarding
return, collection and disposal procedures.
9 Legal information
All legal conditions are subject to the respective national laws of the
country of use and may vary accordingly.
9