Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-484 2 AI 4-20 mA HART Ex i
Figure 27: Example of a FDT/DTM Communication via PROFIBUS
10.3.2
Commissioning on a 750-333, -833 via FDT/DTM
This section describes the most important steps for commissioning the HART I/O
module on a PROFIBUS DP/V1 Fieldbus Coupler 750-333 or Controller 750-833
using FDT/DTM.
Along with the installed and wired fieldbus node hardware, which includes the
PROFIBUS DP/V1 Fieldbus Coupler 750-333 or Controller 750-833, it is
necessary to install the following software before carrying out the operations
described.
Table 41: Software Required for the Commissioning on a 750-333, -833 via FDT/DTM
Name
Pos.
1
WAGO-I/O-CHECK
(optional)
2
GSD files for PROFIBUS
with installation program /
Series 750, 752 and 755
3
WAGOframe
4
WAGO_Profibus_HART_
DTM 759-360
5
WAGO_075x-08xx_DTM DTM for the 75x-8xx
6
HART device DTM(e.g.,
Generic HART DTM from
ICS GmbH)
1.
As is typical for a PROFIBUS application, set up the operating mode "2 AI
+ acyclic PROFIBUS services" using the GSD files. You will find more
detailed information on this in the section "Operating Modes"
> ... > "Setting Up via GSD".
Alternatively you can also open WAGO-I/O-CHECK if available. In this
case, proceed as described in the section "Operating Modes Parameters"
> ... > "Setting Up using WAGO-I/O-CHECK".
Manual
V 1.2.0 HW-Version 04, SW-Version 03
Description of Operation
Description
Commissioning tool for
the WAGO-I/O-SYSTEM
750
Fieldbus-specific software
(e.g., GSD files for
PROFIBUS)
FDT frame application for
parameterization,
commissioning and
diagnostics of devices with
DTM device drivers
DTM for PROFIBUS
controller
DTM for parameterization,
commissioning and
diagnostics of HART-
enabled field devices
69
Item-No.:
759-302
750-910
Download:
www.wago.com
759-370
759-360
Both Download:
www.wago.com
Obtainable from
HART field
device
manufacturers
Advertisement
Chapters
Table of Contents
