Bounce Buster Installation - MotorGuide Tour Pro 82 Operation Maintenance Installation Warranty Manual

TROLLING MOTOR INSTALLATION AND OPERATION
6. Push the pedal into the full heel down position and install the rear screw
on the foot pedal.
a

Bounce Buster Installation

1. Place the trolling motor in the stowed position.
2. Remove the bounce buster from the mounting accessory kit.
Avoid injury from parts flying into the passenger compartment of the boat. If
the bounce buster is not correctly installed, the trolling motor can
inadvertently deploy, which at planning speed could result in catastrophic
failure of the trolling motor. Check that the stow latch fully engages after
installation of the bounce buster.
3. Measure the distance between the boat deck and the outside surface of
the mounting bracket.
4. Add 6.35 mm (1/4 in.) to the measured length (distance between the boat
deck and the outside surface of the mounting bracket) taken in the
previous step.
b
70278
CAUTION
!
a - Distance between the boat deck and the
outside surface of the mounting bracket.
a
70125
a - Rear screw
b - Front screws (2)
22
eng