Table of Contents
Advertisement
TROLLING MOTOR INSTALLATION AND OPERATION
IMPORTANT: To prevent galling of the mounting hardware, do not use a drill
to tighten the mounting screws.
If necessary, shim the rubber washers with 25 mm (1 in.) outside diameter
stainless steel washers to create a level mounting surface.
The mount bracket must lay flush against the rubber isolators before being
bolted to the deck or the mount will bind, making it difficult or impossible to
unlatch.
b
c
d
e
7. Once installed, the bracket should fasten securely and evenly, and
release with a light, quick pull on the stow/deploy handle.
Permanent Foot Pedal Mounting—Optional
1. Determine a suitable location for the foot pedal with the trolling motor
deployed and in the stowed position. Ensure that there are no
obstructions beneath the boat deck that would interfere with the mounting
screws, such as bulkheads or boat wiring.
2. Once a suitable location is chosen, mark the mounting holes, using the
foot pedal as a template.
IMPORTANT: To prevent cracking, use a countersink drill bit or a larger drill
bit to countersink the holes on fiberglass boats.
3. Use a 3 mm (7/64 in.) drill bit to drill holes through the boat deck.
NOTE: Make sure the cables and cable sheathing are not kinked or twisted
before mounting to the boat deck.
4. Use three #8 x 2 in. stainless steel screws to secure the foot pedal to the
boat deck.
5. Push the pedal into the full toe down position and install the two front
screws on the foot pedal.
eng
a
f
a -
Mount bracket
b -
Mounting screw
c -
Rubber isolator
d -
Deck
e -
Washer
f -
Nylon locknut
58753
21
Hide quick links:
Advertisement
Table of Contents
