MotorGuide Tour Pro 82 Operation Maintenance Installation Warranty Manual page 29

TROLLING MOTOR INSTALLATION AND OPERATION
5. Cut the bounce buster to the new measurement on the non‑assembled
end of the bounce buster.
a
a - Distance between the boat deck and outside surface of the mounting
bracket
b - Non‑assembled end
c - Add 6.35 mm (1/4 in.)
d - Bounce buster
6. Move the trolling motor into the deployed position.
NOTE: Removing the steering system from the deployed mount will allow for
easier tightening of the bounce buster screw.
NOTE: The bounce buster will loosen if not fully seated in the bounce buster
pocket.
7. Using the non‑assembled end of the bounce buster, slide the bounce
buster into the bounce buster pocket.
8. Use a pencil or piece of tape to mark a line to indicate when bounce
buster is fully seated in the bounce buster pocket. Mark the line 20 mm
(0.79 in.) from the cut end of the bounce buster.
9. Insert and tighten the bounce buster self‑tapping screw into the bounce
buster pocket.
b
a
eng
d
70137
c
a - Bounce buster pocket
b - Self‑tapping screw
c - Bounce buster
c
23
b
70135