MotorGuide Tour Pro 82 Operation Maintenance Installation Warranty Manual page 64

TROLLING MOTOR INSTALLATION AND OPERATION
Avoid serious injury from colliding with other boats, running aground, or
striking objects in the water. The Pinpoint GPS system cannot detect other
boats, shallow water, or objects in the water. Always beware of possible
obstructions to navigation when operating in any Pinpoint GPS mode.
Avoid injury or property damage due to unintended operation. Certain objects
—especially magnetic metal objects, such as anchors—can affect the GPS
system if they are within or passing through the magnetic field surrounding
the trolling motor. Objects obstructing the GPS signal can also have a
negative effect on system operation. Be mindful of objects close to the trolling
motor, and use care when operating the trolling motor in a GPS‑guided
mode.
Setting Cruise Control
While in heading lock mode or route recall mode, you can set the cruise control
by pressing the cruise control button. The trolling motor will emit one chirp to
indicate that the cruise control has been activated. The system will
automatically set a trolling speed of 1.0 mph (1.6 kph) and will compensate for
current and wind conditions to maintain this speed. Pressing the cruise control
button again will turn the cruise control off, indicated by a descending chirp
from the trolling motor.
While cruise control is turned on, the GPS speed over ground can be adjusted
by pressing the increase speed (+) or decrease speed (–) buttons. Pressing
either button once will adjust the speed by 0.1 mph (0.16 kph) accordingly. For
example, to set the cruise control at 1.3 mph (2.1 kph), press the cruise
control button, then press the increase speed (+) button three times.
To exit cruise control mode from the remote control press the cruise control or
manual buttons on the remote.
WARNING
!
a
a - Increase speed (+)
b - Cruise control
c - Decrease speed (–)
b
c
53023
CAUTION
!
58
eng