Table of Contents
Advertisement
TROLLING MOTOR INSTALLATION AND OPERATION
PINPOINT ALIGNMENT CALIBRATION
IMPORTANT: This calibration is required and must be completed. It should be
repeated when the trolling motor is moved from one boat to another. This
calibration can be done with the boat in or out of the water.
a
e
IMPORTANT: A fixed GPS position is required to complete the pinpoint
alignment calibration. The Pinpoint GPS system will emit an audible tone once
it has acquired a fixed GPS position (in the default audio mode), and the GPS
status indicator light will illuminate.
1. Power up and deploy the trolling motor. Adjust the motor height so that
the bottom of the head is 6 inches above the depth collar and the motor is
clear of any obstructions while turning.
IMPORTANT: Stay a safe distance away from the propeller when the trolling
motor is in an operational mode.
Rotating propellers can cause serious injury or death. Never start or
operate the motor out of water.
2. Use the left turn and right turn buttons to steer the unit so that the lower
unit is parallel to the head, with the nose cone of the lower unit facing
forward and the propeller facing aft.
RESET TO FACTORY CALIBRATION
To reset the trolling motor to the factory calibration, press and hold the manual
mode button, then press 1, 1, 4.
Operating the Pinpoint GPS System
STATUS INDICATOR LIGHT IDENTIFICATION
This trolling motor is equipped with a multifunction status indicator light panel. It
can display the status of the motor, propeller, battery charge, and GPS status
for quick and easy reference during operation.
a -
Left turn
b -
Right turn
b
c -
Manual mode
c
d -
#3 button
e -
#1 button
d
54148
WARNING
!
40
eng
Hide quick links:
Advertisement
Table of Contents
