Table of Contents
Advertisement
TROLLING MOTOR INSTALLATION AND OPERATION
9. Tighten one of the two Allen screws to the specified torque. Then tighten
the second Allen screw to the specified torque. When the second Allen
screw is tightened, verify that the first Allen screw is still tightened to the
specified torque.
10. Tighten the two Allen screws to the specified torque.
Description
Allen screws (2)
a
Trolling Motor Installation
IMPORTANT: It is recommended that the motor be mounted as far forward on
the boat as possible.
Make sure there is nothing obstructing the stowing or deploying of the motor in
and out of the water.
Make sure there are no obstructions underneath the mount to prevent damage
to wires or other obstructions under the hull.
1. Stow the fully assembled motor by pulling on the stow/deploy handle and
raising the motor into the stowed position.
b
a -
Allen screws
b -
360 breakaway housing aligned with the
top of the mount
b
70008
Nm
16.3
18
lb‑in.
lb‑ft
144
–
eng
Hide quick links:
Advertisement
Table of Contents
