Table of Contents
Advertisement
TROLLING MOTOR INSTALLATION AND OPERATION
5. Connect the sonar display to a separate accessory battery with only the
sonar display connected. This will verify if the interference is coming from
the power cables or the transducer cable.
a. If the interference stops when the sonar display is connected to a
separate accessory battery, inspect the boat wiring. Most likely, there
is a problem with the ground (–) connection. All devices should have a
common ground.
b. If the interference continues, it is likely coming from the transducer or
transducer cable.
6. Install a radio frequency (RF) choke onto the sonar display power cable.
7. Connect the sonar display to a different transducer.
Cable Routing Clip Installation
NOTE: The cable routing clips are intended to be used with externally routed
trolling motor accessories that require cables to be routed on the outside of the
shaft of the motor and alongside the mount for a seamless installation on the
trolling motor.
1. Place the motor in the deployed position.
2. After mounting the accessory of choice on the shaft or lower unit of the
motor run the cable on the side of the shaft to the bottom of the 360
breakaway housing.
3. Attach the cable to the bottom of the 360 breakaway housing using the
provided zip tie and screw found in the trolling motor accessory kit.
4. Route the cable from the bottom of the 360 breakaway housing to the top
of the 360 breakaway housing using the zip tie and screw.
5. Insert the cables of the accessory into the front of the cable routing clip
and out of the second slot on the opposite end of the clip.
70022
28
eng
Hide quick links:
Advertisement
Table of Contents
