MotorGuide Tour Pro 82 Operation Maintenance Installation Warranty Manual page 53

TROLLING MOTOR INSTALLATION AND OPERATION
NOTE: Pressing a button multiple times will move the anchor position five feet
for each time the button is pressed.
Storing or Overwriting an Anchor Position
a - Memory buttons (1–8)
a
54420
NOTE: An anchor position can be stored or overwritten from any operating
mode except route record mode.
To store an anchor location, press and hold any of the numbered memory
buttons for two seconds. The unit will emit a tone to indicate that the anchor
position has been stored successfully.
Stored anchor positions cannot be erased, but you can overwrite (record over)
them. A stored anchor position can be overwritten by simply storing a new
anchor position to the desired memory button.
Recalling a Stored Anchor Position
NOTE: A stored anchor position can be recalled from any operating mode.
To recall a stored anchor position, press and release the desired memory
button. The trolling motor will emit an ascending chirp to indicate that a stored
anchor position has been retrieved. If the selected anchor position button does
not have a stored anchor position, or if the anchor location is over one mile
away from your current location, the trolling motor will emit an error tone.
IMPORTANT: If the trolling motor loses the GPS signal while in any GPS
mode, the trolling motor will emit an error tone and automatically return to
manual mode.
IMPORTANT: When recalling a stored anchor position, the system will
calculate a straight‑line course from your current position to the selected
anchor position. Ensure that there are no obstructions to navigation between
your location and the selected anchor position—the system will recall an
anchor point even if obstructions are present. If obstructions are encountered,
navigate around them by operating in manual mode.
47
eng