Table of Contents
Advertisement
TROLLING MOTOR INSTALLATION AND OPERATION
If the selected memory position is empty, or if the boat is over 1.6 km (1 mile)
from a point on the selected route, the trolling motor will emit an error tone and
exit the route mode.
IMPORTANT: If the trolling motor loses the GPS signal while in any GPS
mode, the trolling motor will emit an error tone and automatically return to
manual mode.
Avoid injury or property damage due to unintended operation. Certain objects
—especially magnetic metal objects, such as anchors—can affect the GPS
system if they are within or passing through the magnetic field surrounding
the trolling motor. Objects obstructing the GPS signal can also have a
negative effect on system operation. Be mindful of objects close to the trolling
motor, and use care when operating the trolling motor in a GPS‑guided
mode.
When recalling a stored route, the trolling motor will navigate to the nearest
point on the route, then travel to the most distant end from the boat's current
position. At any time while traveling along a stored route, the direction of travel
can be reversed by recalling the stored route again. Once you have reached
the end of a stored route, the trolling motor will set anchor in the anchor mode
and will emit an ascending chirp to indicate that the boat has arrived at the end
of the stored route.
USING CRUISE CONTROL
Cruise control can be activated while in heading lock mode or route playback
mode to maintain a constant trolling speed. It will automatically adjust the motor
speed to correct for current and wind conditions to maintain a constant speed.
eng
CAUTION
!
57
Hide quick links:
Advertisement
Table of Contents
