IMPORTANT: Trolling motors stored in temperatures below 0 °C (32 °F) should
be operated slowly for a minimum of 15 minutes before going above 30%
operation.
Lubrication Points
NOTE: Preferred lubricants can be obtained at any authorized MotorGuide or
Mercury Marine service center.
To reduce friction and quiet squeaks, lubricate the specified locations
periodically with the following lubricants:
•
Latch hooks ‑ 2‑4‑C with PTFE
•
Latch strikers ‑ 2‑4‑C with PTFE
•
Pivot pins ‑ 4‑Stroke 10W‑30 Outboard Oil
IMPORTANT: Never use an aerosol lubricant to grease or oil any part of the
unit. Many aerosol lubricants contain harmful propellants that can cause
damage to various parts of the trolling motor.
a
b b
c
Tube Ref
Description
No.
2-4-C with PTFE
95
4-Stroke 10W-30
110
Outboard Oil
Battery Inspection
The battery should be inspected at periodic intervals to ensure proper trolling
motor operation.
IMPORTANT: Read the safety and maintenance instructions which accompany
your battery.
1. Ensure that the battery is secured to the vessel.
2. Ensure that the battery cable terminals are clean, tight, and correctly
installed. For installation instructions, refer to Battery Connection.
3. Ensure that the battery is equipped with a battery box to prevent
accidental shorting of the battery terminals.
MAINTENANCE
a
70026
Where Used
Latch pins, latch hooks
Pivot pins
64
a -
Latch hooks
b -
Latch strikers
c -
Pivot pins
Part No.
92-802859A 1
92-8M0078625
eng