Stowing The Trolling Motor - MotorGuide Tour Pro 82 Operation Maintenance Installation Warranty Manual

TROLLING MOTOR INSTALLATION AND OPERATION
IMPORTANT: The clip must be within 2.54 cm (1 in.) of the raised part of the
side plate to avoid damage to the clip when stowing and deploying.
6. Insert the clip, open side up, into the overhang on the top of either side of
the trolling motor mount.
a - Cable routing clip
b - Overhang
c - Top of 360 breakaway housing
d - Bottom of 360 breakaway housing
e - 360 breakaway housing
f - Cable

Stowing the Trolling Motor

Rotating propellers can cause serious injury or death. Never start or operate
the motor out of water.
Moving parts, such as hinges and pivot points, can cause serious injury.
Keep away from moving parts when stowing, deploying, or tilting the motor.
IMPORTANT: Raise the trolling motor out of the water. While holding the
release handle allow the trolling motor to fall into the stow latched position from
the 90° position. Do not release the latch release handle until the stow latch is
engaged.
1. Firmly grasp the stow/deploy handle.
2. Snap the stow/deploy handle to deploy the latch hooks.
eng
b
a
f
!
!
c
e
WARNING
CAUTION
29
d
70156