MotorGuide Tour Pro 82 Operation Maintenance Installation Warranty Manual page 25

TROLLING MOTOR INSTALLATION AND OPERATION
2. Install the tie‑down strap through the slots in the mount, hook‑and‑loop
side down, with the buckle facing toward the outside of the boat.
IMPORTANT: If planning to install the provided bounce buster ensure that the
bounce buster contacts the boat on a desired location prior to drilling holes
and mounting the motor. Refer to Bounce Buster Installation.
IMPORTANT: A minimum of four mounting bolts are required to mount the
trolling motor to the boat. Spread the mounting bolts as far apart as practical
for the most secure mounting.
3. Place the trolling motor on the surface of the boat deck. Use the mount as
a template to mark the locations of the front mounting holes and the rear
mounting holes on the mount.
For a new boat installation
If replacing an existing trolling
motor that uses a 3" hole
pattern
eng
a
b
b
c
70015
Installation Variations
Use the exposed 7.6 cm (3 in.) hole pattern.
Use the exposed 7.6 cm (3 in.) hole pattern
in the base of the mount.
a - Tie‑down strap
b - Slots
c - Buckle
19