Safety Notes - SMART Embedded Computing MVME3100 Installation And Use Manual

Safety Notes

This section provides warnings that precede potentially dangerous procedures throughout
this manual. Instructions contained in the warnings must be followed during all phases of
operation, service, and repair of this equipment. You should also employ all other safety
precautions necessary for the operation of the equipment in your operating environment.
Failure to comply with these precautions or with specific warnings elsewhere in this manual
could result in personal injury or damage to the equipment.
Smart Embedded Computing intends to provide all necessary information to install and
handle the product in this manual. Because of the complexity of this product and its various
uses, we do not guarantee that the given information is complete. If you need additional
information, ask your Smart Embedded Computing representative.
This product is a Safety Extra Low Voltage (SELV) device designed to meet the EN60950-
1 requirements for Information Technology Equipment. The use of the product in any other
application may require safety evaluation specific to that application.
Only personnel trained by Smart Embedded Computing or persons qualified in electronics
or electrical engineering are authorized to install, remove or maintain the product.
The information given in this manual is meant to complete the knowledge of a specialist and
must not be used as replacement for qualified personnel.
Keep away from live circuits inside the equipment. Operating personnel must not remove
equipment covers. Only factory authorized service personnel or other qualified service
personnel may remove equipment covers for internal subassembly or component
replacement or any internal adjustment.
Do not install substitute parts or perform any unauthorized modification of the equipment or
the warranty may be voided. Contact your local Smart Embedded Computing
representative for service and repair to make sure that all safety features are maintained.
EMC
The blade has been tested in a standard Smart Embedded Computing system and found
to comply with the limits for a Class A digital device in this system, pursuant to part 15 of
the FCC Rules, EN 55022 Class A respectively. These limits are designed to provide
reasonable protection against harmful interference when the system is operated in a
commercial environment.
This is a Class A product based on the standard of the Voluntary Control Council for
Interference by Information Technology Interference (VCCI). If this equipment is used in a
domestic environment, radio disturbance may arise. When such trouble occurs, the user
may be required to take corrective actions.
MVME3100 Single Board Computer Installation and Use (6806800M28H) 19