Honeywell Fusion4 MSC-L Installation & Operation Manual page 458

5 - 270
Operation - Calibration
<OK>
11. Select
<ESC>
factor or
<OK>
If is selected, then a message appears informing if you want to
repeat the calibration runs.
12. Following options can be performed.
<OK>
Select

same flow rate.
NOTE: Maximum of 5 calibrations can be performed for a
single flow rate.
<Cancel>
Select

Fusion4 MSC-L
Installation & Operation Manual
on the IR controller or LAD to accept the new meter
to reject the meter factor.
on the IR controller or LAD to repeat calibration on the
to terminate the operation.
Part No.: 4418309_Rev09
Honeywell