Honeywell Fusion4 MSC-L Installation & Operation Manual page 372

Entity
[Alarm action]
[Pump feedback timeout]
5.14.2.4.4 Block Valve Fault
Entity
[Alarm action]
[Feedback timeout]
5.14.2.4.5 Deviation
Entity
[Alarm action]
5 - 184
Operation - Stream Configuration
The Additive Stream Config. . Stream n . No Pump screen is
displayed with the following entities.
Description
With this entity you can configure the
alarm behavior, in case this particular
alarm occurs.
With this entity you can set the time in
seconds in which the additive pump
must provide a feedback to the MSC. If
the feedback from the pump is not
[Pump feedback timeout],
received in
then an alarm occurs depending on the
[Alarm action]
.
On the Additive Stream Config . Stream n . Alarms screen, select
<Block valve fault>.
The Additive Stream Config. . Stream n . Block Valve Fault screen is
displayed with the following entities.
Description
With this entity you can configure the
alarm behavior, in case this particular
alarm occurs.
With this entity you can set the time in
seconds in which the additive pump
must providea feedback to the MSC. If
the feedback from the pump is not
[Feedback timeout]
received in
alarm occurs depending on the
action]
.
On the Additive Stream Config . Stream n . Alarms screen, select
<Deviation>.
The Additive Stream Config. . Stream n . Deviation screen is
displayed with the following entities.
Description
With this entity you can configure the
alarm behavior, in case this particular
alarm occurs.
Fusion4 MSC-L
Installation & Operation Manual
Value range
<Disabled>
(default)
<Display>
<Display shutdown>
<Display pause>
<1> ... <255>
s
<15>
(default =
Value range
<Disabled>
(default)
<Display>
<Display shutdown>
<Display pause>
<1> ... <255>
s
<15>
(default =
, then an
[Alarm
Value range
<Disabled>
<Display>
(default)
<Display shutdown>
<Display pause>
s
s)
s
s)
Part No.: 4418309_Rev09
Honeywell