Honeywell Fusion4 MSC-L Installation & Operation Manual page 338

Entity
[Output (kout)]
[Proportional (kp)]
[Pump run timeout]
[Hydr. pump run timeout]
[Factored pulse out]
[Block valve activation time]
[Factored pulse width]
[Back pressure control]
[Vapour pressure margin]
[Pressure control range factor]
5 - 150
Operation - Stream Configuration
Description
With this entity the collaboration with
the [-1, 1] limiter is used for setting the
operational range of the controller.
For ACV valve type, set it to expected
product flow at 20.0 mA output in
default units.
Example: If Maximum Full Flow Rate is
1800.0 l/m then set it to 1800.
With this entity the gain of the
proportional part of the PI(D) controller
can be set.
With this entity you can enter the time
in minutes between the last injection
and the additive pump stop.
With this entity you can enter the time
in minutes between stopping the blend
stream flow and closing the hydraulic
pump.
With this entity you can select the
amount of pulses for each unit of the
product volume dispensed.
With this entity you can configure the
time that the MSC-L waits after the
activation of block valve before
controlling the DCV. This entity is used
only if the block valve feedback is not
configured.
With this entity you can select the width
of the factored pulse output.
With this entity you can enable back
pressure control.
With this entity, you can adjust
"Minimum limit point" to provide a
'safety' margin above derived vapour
pressure.
Note: In case of "Externally controlled"
vapour pressure, this parameter is
used to derive vapour pressure from
observed product pressure.
With this entity you can adjust
'Maximum limit point' to change the
pressure range where 'back pressure
control' is active
Fusion4 MSC-L
Installation & Operation Manual
Value range
<100.00>
default =
<1.00>
default =
<1> <255>
min ... mins
<10> mins
(default = )
<1> <255>
min... minutes
<10> mins
(default = )
<1 Pulse / Unit>
(default)
<10 Pulses / Unit>
<100 Pulses / Unit>
<1000 Pulses / Unit>
<0> <999>
sec ... secs
<0>
(default = sec)
<1> <500>
msec... msec
<1> msec
(default = )
<Enable>
<Disable>
(default)
<1> Bar
(default = )
Units
<Pascal>
<Kilo Pascal>
<Pounds per Square Inch>
<PSI large>
<Bar>
<0.20> <5.00>
Value = ...
<1.00>
(default = )
Part No.: 4418309_Rev09
Honeywell