Honeywell Fusion4 MSC-L Installation & Operation Manual page 293

5.13.1.2 System Config . Device . I/O Binding
5.13.1.2.1 System Config . I/O bindings . Inputs
Entity
[Emergency shutdown]
[TAS - stand alone switch]
5.13.1.2.2 System Config . I/O bindings . Outputs
Entity
[Emergency stop]
5.13.1.3 System Config . Device . Communication
Part No.: 4418309_Rev09
Honeywell
Operation - System Configuration
1. On the System Configuration screen, select
The System Config . Device . I/O Binding screen appears.
2. On the Device Configuration . I/O Binding screen, select each
entity to configure the MSC-L.
On the System Config . Device. I/O Binding screen, select <Inputs>.
The following entity is displayed.
Description
With this entity you can select the
physical input of the emergency
shutdown input.
With this entity users can select work
flow to be local (Enable) or remote
(Disabled)
On the System Config . Device . I/O Binding screen, select <Outputs>.
The following entity is displayed.
Description
With this entity you can select the
physical output of the emergency stop.
1. On the System Config . Device screen, select <Communication>.
Fusion4 MSC-L
Installation & Operation Manual
<I/O binding>.
Value range
Any of the unused DI-DC-n, DI-AC-n, QPI-
n, AI-n, or None.
<None>
The default value is
Any of the unused DI-DC-n, DI-AC-n, QPI-
n, AI-n, or None.
<None>
The default value is
Value range
Any of the unused DO-SSR, DO-EMR, PO,
or None.
<None>
The default value is
.
.
.
5 - 105