Honeywell Fusion4 MSC-L Installation & Operation Manual page 291

5.13.1.1.4 System Config . General . Time
Entity
[Date display format]
[Time display format]
[Date]
[Time]
5.13.1.1.5 System Config . Device . Settings
Entity
[Bay type (reboot required)]
[Acc. totals reset allowed]
Part No.: 4418309_Rev09
Honeywell
Operation - System Configuration
On the System Config . Device . General screen, select <Time>. The
following entities are displayed.
Description
With this entity you can select the
format of the date.
Note: The local site time must be
configured (synchronized) in the MSC-
L, to have all the transactions and the
alarms being timestamped correctly in
the local time.
The MSC-L does not support Daylight
Saving Time.
With this entity you can select the
format of the time.
With this entity you can select the
actual date that is used for time
stamping of transactions, calibrations,
and alarms.
With this entity you can select the
actual time that is used for time
stamping of transactions, calibrations,
and alarms.
On the System Config . Device . General screen, select <Settings>. The
following entities are displayed.
Description
With this entity you can select the
necessary bay
With this entity you can enable / disable
the ability to reset accumulator totals
Fusion4 MSC-L
Installation & Operation Manual
Value range
<DD-MM-YY>
(default)
<MM-DD-YY>
<YY-MM-DD>
<DD-MM-YYYY>
<MM-DD-YYYY>
<DD/MM/YYYY>
<MM/DD/YYYY>
Note: Only the first three selections are
completely visible on the MSC-L screen.
<12-hour>
<24-hour>
(default)
Note: Only the 24-hour selection is
completely visible on the MSC-L screen.
<Year>
<Month>
<Day>
Note: By default, the current date appears.
To change the default date, enter the year,
month, and day.
<Hour>
<Minute>
<Second>
Note: By default, the current time appears.
To change the default time, enter the hour,
minute, and second.
Value range
<Single bay>
<Dual bay>
.
<No>
(default)
<Yes>
.
5 - 103