Honeywell Fusion4 MSC-L Installation & Operation Manual page 373

Entity
[Add. volume deviation]
[Num. cycles for alarm]
5.14.2.4.6 Fixed
Entity
[Control fault]
[Solenoid fault]
[Pulse hardware]
[Pulse phase]
[Factored pulse out]
[Temperature sensor]
Part No.: 4418309_Rev09
Honeywell
Operation - Stream Configuration
Description
With this entity you can set the
percentage of additive volume that is
accepted without resulting in an alarm
situation. If this percentage is
exceeded, an alarm occurs depending
[Alarm action]
on the . The alarm is
evaluated after every injection.
With this entity you can set the number
of additive injection cycles over which
the deviation is calculated.
On the Additive Stream Config . Stream n . Alarms screen, select
<Fixed>.
The Additive Stream Config. . Stream n . Fixed screen is displayed
with the following entities.
Description
With this entity you can configure the
[Control fault]
alarm in case this
particular alarm occurs.
With this entity you can configure the
[Solenoid fault]
alarm in case this
particular alarm occurs.
With this entity you can configure the
[Pulse hardware]
alarm in case this
particular alarm occurs.
With this entity you can configure the
[Pulse phase]
alarm in case this
particular alarm occurs.
With this entity you can configure the
[Factored pulse out]
alarm in case this
particular alarm occurs.
With this entity you can configure the
[Temperature sensor]
alarm in case this
particular alarm occurs.
Fusion4 MSC-L
Installation & Operation Manual
Value range
<1> ... <100>
% %
<10>
(default = %)
<1 ... 99>
<1>
(default = )
Value range
<Disabled>
<Display>
(default)
<Display shutdown>
<Display pause>
<Disabled>
<Display>
(default)
<Display shutdown>
<Display pause>
<Disabled>
<Display>
<Display shutdown>
(default)
<Display pause>
<Disabled>
<Display>
<Display shutdown>
(default)
<Display pause>
<Disabled>
<Display>
<Display shutdown>
(default)
<Display pause>
<Disabled>
<Display>
<Display shutdown>
(default)
<Display pause>
5 - 185