Honeywell Fusion4 MSC-L Installation & Operation Manual page 336

5.14.1.2.2 The I/O Bindings . Output Parameters
Entity
[NO DCV]
[NC DCV]
[Low flow 2SV]
[High flow 2SV]
[Pump demand]
[Block valve control]
[Hydraulic pump
demand]
[Factored pulse output]
[Recirculation NO DCV]
[Recirculation NC DCV]
[Analog control valve]
5.14.1.2.2.1 Pump Demand
5.14.1.2.2.2 Block Valve Control
5.14.1.2.2.3 Hydraulic Pump Demand
5 - 148
Operation - Stream Configuration
NOTE: The default value for all the Output entities are None.
Description
With this entity you can select the physical
source for the DCV function.
With this entity you can select the physical
source for the DCV function.
With this entity you can select the output
used in a two stage value to enable low
product flow (output is also enabled in high
flow stage).
With this entity you can select the output
used in a two stage value to enable high
product flow.
With this entity you can select the physical
source for the pump demand function.
With this entity you can select the physical
source for the block valve control function.
With this entity you can select the physical
source for the hydraulic pump demand
function.
With this entity you can select the physical
source for the factored pulse output.
With this entity you can select the physical
source for recirculation NO DCV.
With this entity you can select the physical
source for recirculation NO DCV.
With this entity you can select the physical
source for Analog control valve.
Product stream pump demand output should be driven high when

the batch starts (if the
The pump is de-activated when the batch stops and

is elapsed.
[Block valve]
If the

should be active when the batch starts.
If the block valve should remain active until the product stream stops

or pauses.
Product stream hydraulic pump demand output should be driven

high when the batch starts (if the
defined).
Fusion4 MSC-L
Installation & Operation Manual
Can be linked to...
Any of the unsed DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused DO-EMR-n, DO-SSR-n,
PO-n, or None.
Any of the unused
[Pump demand]
I/O binding is defined).
I/O binding is defined, then the block valve output
[Hydraulic pump demand]
AO-n
[Pump run timeout]
I/O binding is
Part No.: 4418309_Rev09
Honeywell