Honeywell Fusion4 MSC-L Installation & Operation Manual page 312

5.13.1.5.3.1 Deadman Status
Entity
[Deadman status]
5.13.1.5.3.2 Deadman Indicator
Entity
Output]
[
[Timeout]
5.13.1.5.3.3 Deadman bell
Entity
Output]
[
[Timeout]
5 - 124
Operation - System Configuration
The System Config . Alarms . Deadman screen appears. The
deadman function of the MSC-L allows the loading process to be
monitored to ensure the operator's attention and safety during the
loading operation.
2. On the System Config . Alarms . Deadman screen, the following
entities are displayed.
Description
With this entity you can
<Disable>
deadman alarm function.
If enabled, the operator/driver must
repeatedly (within the settable timeout
period) press a key on the keyboard of
the MSC-L or press deadman refresh
switch to prevent the deadman function
from being triggered.
Description
With this entity you can select the
physical output for the deadman
indicator function.
With this entity you can set the time in
seconds in which the operator must
press a key or refresh the deadman
switch in an interval of
indicator timeout]
to prevent the
deadman indicator (warning) lamp from
being activated and deadman bell
(siren) start the beep.
Description
With this entity you can select the
physical output for the deadman bell
function.
With this entity you can set the time in
seconds in which after the deadman
indicator output activates, the operator
must press a key or deadman switch
refresh to prevent the batch from being
paused and deadman bell activate
continuously.
Fusion4 MSC-L
Installation & Operation Manual
Value range
<Enable> <Enable>
or
<Disable>
Value range
Any of the unused DO-SSR, DO-EMR, PO,
or None.
The default value is
<10> s ... <999> s
(default =
[Deadman
Value range
Any of the unused DO-SSR, DO-EMR, PO,
or None.
The default value is
<10> s ... <999> s
(default =
(default)
<None>
.
<150> s
)
<None>
.
<30> s
)
Part No.: 4418309_Rev09
Honeywell