Dsv-Digital Vertical Shift; Dtl-Detail; Dzh-Digital Horizontal Zoom - Christie 599 GS Series Technical Reference

DSV–Digital Vertical Shift
Moves the projector image up or down. If the image is not zoomed out (Digital Zoom), this command
is disabled.
Commands
Command Description
DSV <value> Moves the projector to the up or
down. (Write-only)
Examples
Center the display area vertically:
(DSV 50)
DTL–Detail
Applies a predefined sharpness setting to the current input signal.
Commands
Command Description
DTL <value> Sets the sharpness setting.
Examples
Set the sharpness setting to low:
(DTL 1)
DZH–Digital Horizontal Zoom
Changes the size of the horizontal display area.
If the display area has been resized with this setting, use the DSH—Digital Horizontal Shift and DSV—
Digital Vertical Shift commands to readjust the image.
GS Series 599 Serial Commands Technical Reference
020-102403-02 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Values
0 to 100
0 = Moves the display area to the top
50 = Centers the display area vertically (Default)
100 = Moves the display area to the bottom
Values
0 = Maximum
1 = High
2 = Normal
3 = Low
4 = Minimum
Serial API commands
23