Lpi-Constant Intensity - Christie 599 GS Series Technical Reference

Command Description
Examples
Set the language to French:
(LOC+LANG 2)
Set the language to Russian:
(LOC+LANG 7)
LPI–Constant Intensity
Adjusts the light source intensity.
Note the following about the LPI command:
• The light sensor must be calibrated for Constant Intensity mode to work properly. The
calibration must be performed after the laser diode replacement.
• The LPI and LPP (on page 38) commands cannot be enabled at the same time. If one is
enabled, the other command is automatically disabled.
Commands
Command Description
LPI <value> Sets the light source intensity.
Examples
Set the light source intensity to five:
(LPI 5)
GS Series 599 Serial Commands Technical Reference
020-102403-02 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Serial API commands
Values
4 = Italian
5 = Japanese
6 = Korean
7 = Russian
8 = Spanish
Values
0 to 10
7 (Default)
37