Con-Contrast; Crv-Curve Geometry Correction - Christie 599 GS Series Technical Reference

Command Description
Examples
Set the top-left vertical adjustment value to 20:
(CNR+TLCY 20)
CON–Contrast
Sets the image white level by adjusting the gain applied to the input signal.
This command adjusts the degree of difference between the lightest and darkest parts of the image
and changes the amount of black and white in the image.
Commands
Command Description
CON <value> Sets the degree of difference between the lightest and darkest
parts of the image and changes the amount of black and white in
the image.
Examples
Set the contrast value to 50:
(CON 50)
CRV–Curve Geometry Correction
Corrects the symmetry of a constant radius horizontal or vertical curve by modifying the top and
bottom of the image.
Note the following:
• Compound curves are not supported.
• The projector should be mounted perpendicular to the chord of the curve within the offset
limitation of the lens used (ideally on axis).
• There is no tilt correction.
• This command is not available if a Dual Processor Warp module (DPWM) is not installed.
Commands
Command Description
CRV+TARC <value> Applies a top arc adjustment. (Write-only)
GS Series 599 Serial Commands Technical Reference
020-102403-02 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Serial API commands
Values
0 (Default)
Values
0 to 100
Values
0 to 300
150 (Default)
20