Table of Contents
Advertisement
Examples
Set user message boxes to not be displayed:
(MBE+USER 0)
Result:
OFF
Set user message boxes to be displayed:
(MBE+USER 1)
Result:
ON
MDT–Mode Adjustment
Adjusts the horizontal and vertical start position for a signal in the EDID timing table and record the
values in the system to override the timing table.
Run a Save command to keep the settings before exiting. To revert to the original timing table
settings, manually clear each setting. You cannot use the Factory Defaults command to clear these
settings.
Commands
Command
Description
MDT?
Returns the current mode adjustment settings.
MDT+HPOS <value>
Applies a horizontal offset. (Write-only)
MDT+VPOS <value>
Applies a horizontal offset. (Write-only)
MDT+SAVE <value>
Saves the settings. (Write-only)
MDT+CLER <value>
Clears the setting. (Write-only)
Examples
Return the current mode adjustment settings:
(MDT?)
Apply a horizontal offset to the specified position:
(MDT+HPOS 123)
Save the MDT settings:
(MDT+SAVE 1)
Clear the MDT settings:
(MDT+CLER 1)
GS Series 599 Serial Commands Technical Reference
020-102403-02 Rev. 1 (04-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
Serial API commands
Values
—
<value> = Three numeric
characters
<value> = Three numeric
characters
<value> = One numeric
character
<value> = One numeric
character
40
Advertisement
Table of Contents
