Observe Signal States (Monitoring) - Festo CPX-CTEL4-M12-5POL Manual

3. Commissioning

3.7.2 Observe signal states (monitoring)

2:CTEL
Monitoring/Forcing (M)
Diagnostics (D)
Parameters (P)
Fail safe (F)
Module data (MD)
1
Channels of the device at the first assigned I-port (here input module)
2
Channels of the devices at further assigned I-ports (here output module)
Fig. 3/2: Submenu M – Signal statuses of the connected devices
Festo P.BE-CPX-CTEL-EN en 1205NH
You can use the Handheld to observe the signal statuses of
the connected (and recognised) I-port devices.
2:CTEL:M
Process state
Input Ch 0: 32
Input Ch 1: 0
Input Ch 2: 16
...
Output Ch 0: 4
Output Ch 1: 0
Output Ch 2: 0
...
"Force", "Idle mode" and "Fail safe"
Warning
The connected actuators can move unexpectedly!
Modification of the signal statuses and parameters with
the Handheld can trigger dangerous movements of the
connected actuators.
Make sure that nobody is in the positioning range of the
•
connected actuators and be very careful with the para-
meterisation or manipulation of signal statuses.
It is imperative that you observe the instructions on
•
"Force", "Idle mode" and "Fail safe" in the CPX system
description and in the description for the Handheld if the
CPX fieldbus used supports these parameterisation
types.
1
2
3-25