Event Codes - Festo CPX-CTEL4-M12-5POL Manual

A. Technical appendix
A.2

Event codes

Event code Error instance
--- Internal
--- Internal
--- Internal
--- Internal
0x.... I-port device
0x0000 I-port device
0x1000 I-port device
0x4000 I-port device
0x4210 I-port device
0x4220 I-port device
0x5000 I-port device
0x5010 I-port device
0x5011 I-port device
0x5012 I-port device
0x5100 I-port device
0x5101 I-port device
0x5110 I-port device
0x5111 I-port device
Festo P.BE-CPX-CTEL-EN en 1205NH
Within the I-port communication between CTEL master and
device, so-called events are used for status diagnostics,
which include an error code (event code), each with a con-
stant length of 2 bytes. Tab. A/4 shows an overview of the
event codes and the corresponding error description. See
also Tab. 4/3.
Description
Short circuit at I-port (PS/PL supply or commu-
nication signal)
I-port configuration error
I-port device missing/failed
Invalid parameters received from the host
(parameterisation error)
All other event codes not specified in this list
Device OK
Device NOK, general diagnostics
Temperature overload
Device has exceeded temperature limit
Device has fallen below temperature limit
Hardware error – device replacement
Component error – repair or replacement
Error in memory buffering - check batteries
Low battery level – check batteries
General error in power supply
Fuse triggered
Primary voltage/main power supply too low
Primary voltage/main power supply too low
CPX error no.
56
58
57
29
1
0
1
1
10
9
1
1
9
9
1
1
10
5
A-7