Festo CPX-CTEL4-M12-5POL Manual page 8

Contents and general instructions
Intended use
VI
The CTEL master module described in this description has
been designed exclusively for use in combination with CPX
terminals from Festo.
The CTEL master module provides 4 I-port interfaces to the
outside, on each of which a device with I-port interface can be
connected (see section 1.2).
The individual I-port devices are documented in specific de-
scriptions. The safety instructions listed there must always be
observed and the device must only be used as intended.
The CPX terminal and the connected CTEL master module
may be used only as follows:
– as intended in an industrial environment.
– in its original status, without unauthorised modifications.
Only the conversions or modifications described in the
documentation supplied with the product are permitted.
– in excellent technical condition.
If used together with additional commercially available com-
ponents, such as sensors and actuators, the specified limits
for pressures, temperatures, electrical data, torques etc.
must be observed.
Observe the regulations of the trade associations, German
Technical Control Board (TÜV), VDE stipulations or corres-
ponding national laws and regulations.
Festo P.BE-CPX-CTEL-EN en 1205NH