Table of Contents
Advertisement
Press the
button several times to go back to the main screen.
6.7.2 Setpoint Submenu
To set the setpoint of the cooling and/or heating, press
Chiller mode:
Heat pump mode:
To modify the setpoint, click the element "Cooling" or "Heating" setpoint then press the
The element starts to flash.
Increase or decrease the value using the
Confirm the modification by pressing the
In this screen it is also possible to verify (but not modify) whether the energy saving mode and dynamic set
are active. If they are active, the Real set may different from the Cooling or Heating set.
Cooling (Heating) set is always the same as par ST01(ST04), the real set represent the set-point value
including the energy saving delta or of the dynamic set, and it is read only (can't be modified).
1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx
button and enter the set-point screen.
and
buttons.
button again.
button:
iProCHILL
75/205
Advertisement
Table of Contents
